Glazes
Slip casting
Mixing casting slip from dry powder: how much water, how much deflocculant, and how much the clay shrinks.
How much water
Weigh the dry powder. This gives the water to add so the slip comes out at the weight you want.
Specific gravity is how heavy the slip is next to water. 1.78 means 100 ml of slip weighs 178 g. Most casting slips sit between 1.75 and 1.80.
Add water
2.02 litres
2022 ml, or 2022 g on the scale
Makes about 3.94 litres of slip weighing 7.02 kg. The water is 40.4% of the powder weight.
Put the water in the bucket first, with the deflocculant, then add the powder a little at a time while mixing.
Check a cup
Put a measuring cup on the scale, set it to zero, fill it to exactly 100 ml with slip and read the weight.
Enter the weight to see the specific gravity and what to add.
Deflocculant
A few drops make the slip runny without more water, which is what keeps shrinkage down. A starting dose is 0.25 to 0.5% of the dry powder weight.
For 5 kg of dry powder
12.5 g to 25 g
That is about 8.9 to 17.9 ml. Too many drops to count: use a syringe or the scale.
Add a little at a time. Start with half the low figure in the water, mix in the powder, then add a few drops at a time and stir until it pours like cream.
Too much makes the slip thick again, and it cannot be taken back out. Stop as soon as more drops make no difference.
If the bag is a ready-made casting slip powder, it may already contain deflocculant. Check before adding any.
Drops are a rough guide (sodium silicate taken as 1.4 g per ml, 20 drops per ml). Every clay needs a different amount, so go by how the slip pours.
Shrinkage
Cast a flat bar, mark a 100 mm line on it while it is still wet, then measure the same line when it is bone dry and again after firing.
Enter the dry and fired lengths.
Drying and total are a share of the wet length; firing is a share of the dry length. This holds for one clay, one slip recipe and one firing temperature: test again if any of them changes.
Absorption
How much water the fired clay still takes in. Weigh a fired, unglazed, dry piece. Boil it in water for two hours, let it cool in the water, wipe the surface and weigh it again.
Enter both weights.
Slip not behaving? Ask the mentor.