Skip to content
Techniques

Technique

Burnishing

Polish until the clay shines from within.

Burnishing (Maria Martinez pot)
Photo Cullen328 / Wikimedia Commons, CC BY-SA 3.0

Polishing raw clay with a stone until it shines without any glaze.

Burnishing presses the fine clay particles flat so the surface reflects light. It is done at leather-hard with a smooth stone, a spoon or the back of a bone, often over a fine slip or terra sigillata. Potters from ancient Egypt to San Ildefonso Pueblo to Rwanda have used it to give bare clay a soft gloss.

The shine survives only low firings, around cone 010 to 06; higher temperatures dull it. It pairs naturally with pit, saggar and smoke firing.

What does a surface feel like when it was made only by hand and stone?

Try it in the studio

Burnish a leather-hard pot, rest it, burnish again when bone-dry, and bisque low; then try a smoke or saggar firing.